First canoe build and it was all going so well (other than dropping it mid build once).

Got the first two coats of Epoxy on last night prior to rain forced play to stop.

I thought it was covered - but by tarp isn't as water tight as i thought and i woke up today to find drip and run marks on / in the epoxy.

Some look to be surface only and the plan is a light sanding then more coats over the top.

However - some seem to be under the fiber weave / epoxy and have run down the inside leaving an internal white mark.

Is this now staying unless I re-apply the entire coat (which is near impossible).

Second issue is i have a few voids under the fiberglass / epoxy of air. Is there a standard way of "fixing" this? I was leaning towards drilling some small holes and injecting more Epoxy.



Edit - Pictures;
https://imgur.com/a/fyBKiJV
https://imgur.com/a/w72gSD7